Speech Input Control Module (J507), Through 29 May 2009

Speech Input Control Module (J507), Through 29 May 2009

The Speech Input Control Module is located in the Radio (MMI) behind luggage compartment right side trim.

- Switch off all electrical consumers.

- Remove the key.

- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine.

Use the Vehicle Diagnosis, Testing and Information System (VAS 5051) to do so.

Removing

- Remove the MMI radio (through 29 May 2009). Refer to => [ MMI Radio, Through 29 May 2009 ] MMI Radio, Through 29 May 2009.

- Open cover - 2 - of radio and fold it down - arrow -.





- Carefully pull Speech Input Control Module - 1 - out of radio in direction of arrow.

Installing

- Install in reverse order of removal.

- Make sure that harness connector between Speech Input Control Module and radio engages correctly in radio.

Perform the following function test:

- Switch on the radio.

- Briefly depress PTT button on multifunction steering wheel.

A Ping tone sounds, the speech input system is active.

- Say the command "Help"

Since the radio is active, the speech dialog system responds with "Commands for the radio are...".

Depending on the equipment, other functions can be selected:

- If a telephone is installed, say "telephone".

The speech dialog system switches to the telephone mode.

- Press the PPT button for approximately 1 second.

The speech dialog system responds with "Cancel" and is deactivated.