Trim Moldings and Trim

Trim Moldings and Trim

• It is not possible to remove the moldings and trim without breaking them because they are attached with two-sided tape.

• Warming the cover with a hot air gun will make it easier to remove.

• The vehicle must be room temperature before installing bonded strips, trim panels, etc.

• The adhesive surfaces on the body must be free of dirt and grease.

• Clean the adhesive surfaces using Cleaning solution (D 009 401 04).

• Warm the adhesive areas to approximately 104° F (40° C) using a hot air gun.

• After installing, take the roller and press the brand emblems one more time.