Fenders

Fenders

• Depending on equipment, additional components must be removed before removing fender.






1 Fender Flange

• Fender removed.

• Remove screws - 2 -.

2 Bolt

• 8 Nm

3 Bolt

• 10 Nm

4 Brace For Fender

5 Fender

• Removed

6 Internally Threaded Pop Rivet

Remove Fender

• This must be removed beforehand on vehicles with a parking or auxiliary heater.






1 Fender

• Loosen washer fluid reservoir on right side and secure with welding wire.

• Front wheel removed.

• Wheel housing liner removed.

• End plate removed.

- Remove screws - 2 - and - 8 -.

- Remove screws - 5 - from fender flange.

- Drill lowest rivet from water deflector out of angle bracket - 7 -

2 Bolt

• 15 Nm

3 Brace For Fender

4 Fender Flange

• Can be replaced.

5 Combination Screw

• 15 Nm

6 Bolt

• 5 Nm

7 Angle

8 Bolt

• 15 Nm

End Plate, Removing

• On vehicles with auxiliary heater, wiring bracket on left side must be loosened and pressed to side so screws - 8 - are accessible.

• Loosen washer fluid reservoir on right side and secure, for example, with welding wire.

- Remove screws - 1 -.

- When installing, tighten to 1.5 Nm