Exhaust System, Installing

Exhaust System, Installing

• Align exhaust system when cold.

- Remove front clamping sleeve bolts items - 10 - => [ Front Clamping Sleeve ] Exhaust System Assembly Overview and - 12 - => [ Front Clamping Sleeve ] Exhaust System Assembly Overview.

- If equipped, remove rear clamping sleeve bolts items - 4 -=> [ Rear Clamping Sleeve ] Exhaust System Assembly Overview and - 6 - => [ Rear Clamping Sleeve ] Exhaust System Assembly Overview.

- Press exhaust system forward - arrow - until the following tensions are set on the individual retaining loops.





• Front right retaining loop: Dimension - a - = 2 mm.

• Front left retaining loop: Dimension - a - = 4 mm.





• Rear left and right retaining loops: Dimension - a - = 10 mm.





- Hold exhaust system in this position and tighten clamping sleeve bolts evenly to 23 Nm.

• A 2nd technician is needed to align the exhaust system with clamping sleeves between center and rear mufflers.

• If all adjustment dimensions are not achieved, remove affected bracket from body and shift accordingly.

- Align end pipes => [ Attach end pipe to rear muffler and align. ] Service and Repair.