Left Temperature Door Motor (V158) - Comfort Version
Left Temperature Door Motor (V158) - Comfort Version
• Installed only in vehicles with Comfort version A/C system
• On vehicles with Basic version of Climatronic Control Module (J255) , left and right temperature doors are operated by the Left Temperature Door Motor (both left and right doors are connected to each other via a shaft, motor is installed at right on heating & A/C unit).
• Left Temperature Door Motor - Basic version, removing and installing, refer to => [ Right Temperature Door Motor (V159) (or Left Temperature Door Motor (V158)) ] Right Temperature Door Motor (V159) (or Left Temperature Door Motor (V158)).
• Left Temperature Door Potentiometer/Actuator (G220) is installed in Left Temperature Door Motor.
Removing
- Remove retaining plate - C - with control motors (V108) and (V158) => [ Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158) ] Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158).
- Mark the control motors if necessary (versions vary, refer to Electronic Parts Catalog).
- Remove bolts - D - from Left Temperature Door Motor - B - and remove the motor.
Installing
Remove control motor on retaining plate.
- Install retaining plate - C - with control motors (V108) and (V158) => [ Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158) ] Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158).
• Check the lever position of the control motors before installing retaining plate, the retaining plate can only be installed correctly when it is located in the service position, refer to => [ Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158) ] Retaining Plate With Left Footwell Door Motor (V108) and Left Temperature Door Motor (V158).
- Install the removed components again in reverse order.
- Check DTC memory of Climatronic Control Module and erase DTCs displayed if necessary using the Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding".
- If necessary, perform a basic setting and output diagnostic test mode on the A/C system using the Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding".