Right Rear Temperature Door Motor (V314)

Right Rear Temperature Door Motor (V314)

• With the Right Rear Temperature Door Position Sensor (G392)

Removing

- Switch off ignition.

- Remove left side wall trim in luggage compartment..

- Remove (unhook) lever - 2 - from Right Rear Temperature Door Motor.






- Remove screws - 1 -.

- Disconnect electrical connection from Right Rear Temperature Door Motor and remove control motor.

Installing

- Install the removed components again in reverse order.

- Check DTC memory of Climatronic Control Module (J255) (and of Rear A/C Display Control Head (E265) ) and erase any DTCs displayed using Vehicle Diagnosis, Testing and Information System VAS5051 in the "Guided Fault Finding" function.

- If necessary, perform a basic setting and output diagnostic test mode on the A/C system using Vehicle Diagnosis, Testing and Information System VAS5051 in the "Guided Fault Finding" function.