Instrument Panel Central Tube Angled Bracket

Instrument Panel Central Tube Angled Bracket

Removing






- Remove instrument panel central tube. Refer to => [ Instrument Panel Central Tube ] Instrument Panel Central Tube.

- For reinstallation, mark the left and right installation location of the central tube angle bracket in the height and side positions with respect to the A-pillar.

- Remove screws - 1 - and - 2 - and remove mounting bracket.

Installing

Install in reverse order of removal. Note the following:

- Align the central tube angle bracket according to the markings applied on the A-pillars during removal.

- When installing a new angle bracket, remove centering pin - 3 - if necessary after installing instrument panel central tube.

• If the angle bracket is attached after replacement of the A-pillar and there is no installation mark, transfer the installation dimensions of the angle bracket to the opposite side.

- Install instrument panel central tube. Refer to => [ Instrument Panel Central Tube ] Instrument Panel Central Tube.

• Tightening specifications, refer to => [ Instrument Panel Central Tube Overview ] Instrument Panel Central Tube Overview.