B-Pillar Trim Molding

B-Pillar Trim Molding

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

• Heat gun (V.A.G 1416)

Removing





Proceed as follows:

- Carefully warm the trim molding - 3 - with the hot air gun (V.A.G 1416).

- Carefully remove the trim molding from the lower rear side panel - 5 - using the trim removal wedge (3409) bye removing the securing tabs - 1 - and - 4 -.

Installing

- Clean adhesive surfaces with cleaning solution (D 009 401 04).

- Remove the protective film from the adhesive tape - 2 -.

- Position the trim molding on the lower rear side panel by pressing the securing tabs - 1 - and - 4 - into the mounts.

- Press the trim molding completely onto the lower rear side panel.

• Resting time approximately 2 hours at room temperature