Drawer With Bracket

Drawer with Bracket

• The drawer and bracket removal and installation procedure is described for a power seat. The procedure is similar for a manual seat.

Removal





CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

- Remove seat:

• Manual seats, refer to => [ Seat ] Manual Seats.

• Power seat, refer to => [ Seat ] Power Seats.

- Secure the seat on the (VAS 6136), refer to => [ Installing Seat On VAS 6136 ] Installing Seat on VAS 6136.

- Remove the bolts - 2 -.

- Remove the drawer with the bracket - 1 - from the seat - 3 -.

Installation

Installation is reverse of removal, but note the following:

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

- Switch on ignition.

CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

Tightening specifications, refer to => [ Drawer Assembly Overview ] All Seats Overview.