Side Trim
Side Trim
Special tools, testers and auxiliary items required
• Engine and Transmission Holder (VAS 6095)
• Fixture for Seat Repair (VAS 6136)
1 Bolt
• 1.2 Nm
2 Sill Side Trim
Removal
- Remove the seat. Refer to => [ Seat ]. Seat
- Mount the (VAS 6136) on the (VAS 6095).
- Attach the front seat to the (VAS 6136).
- Remove hand wheel for backrest adjustment - 12 -.
- Unclip the outer side trim - 15 -
- Remove the side trim with the cover - 11 -.
- Remove bolt - 14 - at handle for height adjustment.
- Remove handle for height adjustment - 13 -.
- Remove expanding clip - 16 -, press clamping pin through to the inside.
- Remove mounting bolt - 1 -.
- Separate the cable ties.
- Remove side panel at lower edge from retaining bracket on seat.
- Swing side panel upward at front edge.
- Remove side panel to side.
- Pull tab at rear of side panel out under backrest trim.
- Mark and release the electrical connector retainers.
- Free up electrical wiring.
Installation
To install, perform the steps used in removal in reverse order.
3 Bolt
• 0.4 Nm
4 Button for Seat Bolster Inflation Adjustment
• Driver Seat Bolster Inflation Adjustment Button (E587)
• Front Passenger Seat Bolster Inflation Adjustment Button (E588)
• Removing and installing, refer to => [ Backrest Bolster and Seat Bolster Adjustment Button ] Backrest Bolster and Seat Bolster Adjustment Button
5 Bolt
• 0.4 Nm
6 Button for Backrest Bolster Inflation Adjustment
• Driver Backrest Bolster Inflation Adjustment Button (E589)
• Front Passenger Backrest Bolster Inflation Adjustment Button (E590)
• Removing and installing, refer to => [ Backrest Bolster and Seat Bolster Adjustment Button ] Backrest Bolster and Seat Bolster Adjustment Button
7 Bolt
• 0.4 Nm
8 Lumbar Support Adjustment Switch
• Driver Seat Lumbar Support Adjustment Switch (E176)
• Front Passenger Seat Lumbar Support Adjustment Switch (E177)
• Removing and installing, refer to => [ Backrest Bolster and Seat Bolster Adjustment Button ] Backrest Bolster and Seat Bolster Adjustment Button
9 Side Tunnel Side Trim
Removal
- Remove the seat. Refer to => [ Seat ]. Seat
- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).
- Attach the front seat to the fixture for seat repair (VAS 6136).
- Remove expanding clip - 10 -, press clamping pin through to the inside.
- Disengage retaining detent at rear side of side panel on tunnel side.
- Remove the trim.
Installation
To install, perform the steps used in removal in reverse order.
10 Spreader Clip
11 Cover
12 Hand Wheel for Backrest Adjustment
• Removing and installing, refer to => [ Backrest Adjustment Hand Wheel ] Backrest Adjustment Hand Wheel
13 Handle for Seat Height Adjustment
14 Bolt
• 22 Nm
• Replace with locking compound
15 Side Panel on Outside
16 Spreader Clip
Side Trim, Removing And Installing
- Release the clips - arrows - and remove the outer side trim - 2 - with cover - 1 -.
- When installing, press the outer side trim on until it engages audibly.
Tightening specification for Control Module
- Tighten the bolts - arrow - to 1.5 Nm.