Spring Mat

Spring Mat

• Removal and installation is the same on the driver and passenger seat.

Removal





CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

- Remove the seat. Refer to => [ Seat ]. Seat

- Secure the seat on the (VAS 6136). Refer to => [ Installing Seat On VAS 6136 ] Installing Seat on VAS 6136.

- Remove backrest cover panel. Refer to => [ Backrest Cover ] All Seats.

- Remove the headrests. Refer to => [ Headrests with Locking Mechanism ] All Seats.

- Remove cover with upholstery. Refer to => [ Backrest Cover and Upholstery ] Seat Covers and Upholstery.

- Disengage the pull-springs - 3 - on the backrest frame - 1 -.

• The pull-springs - 3 - can also stay engaged in the backrest frame - 1 - and the spring mat - 2 - can be disengaged directly at the pull-springs.

- Tip spring mat - 3 - forward.





- Remove spring mat - arrows - from backrest frame - 1 -.

2 Pull-spring

Installation

Installation is reverse of removal, but note the following:

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity ". For example, by briefly touching the door striker pin.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.

- Make sure the correct pull-spring (number of coils) is engaged at the location determined.

- Switch on ignition.

CAUTION!
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.