Oil Pump and Lower Section of Oil Pan Assembly Overview
Oil Pump and Lower Section of Oil Pan Assembly Overview
1 Oil drain plug
CAUTION!
Danger to the oil pan thread.
• Lubricate the oil drain plug threads.
• Tighten the oil drain plug using a torque wrench.
• 10 Nm
2 Seal
• Replace
3 Bolt
• Tightening specification and sequence, refer to => [ Lower Section of Oil Pan, Tightening Specifications
and Sequence ]
4 Oil pan lower section
• Removing and installing, refer to => [ Oil Pan Lower Section ] Oil Pan Lower Section
5 Centering pins
6 Oil drain plug
CAUTION!
Danger to the oil pan thread.
• Lubricate the oil drain plug threads.
• Tighten the oil drain plug using a torque wrench.
• 10 Nm
7 Seal
• Replace
8 Bolt
• 5 Nm
9 Gasket
• Replace
10 Gasket
• Replace
11 Driveshaft for oil pump
12 O-ring
• Replace
13 Intake tube
• For oil pump
14 Bolt
• 9 Nm
15 Gasket
• Replace
16 Oil pump
• Do not disassemble
• With relief valve
• Removing and installing, refer to => [ Oil Pump ] Oil Pump
17 Fitting sleeves
• 2 pieces
18 Gasket
• Replace
19 Driveshaft for coolant pump
20 Bolt
• 9 Nm
21 Gasket
• Replace
22 End cover
• Removing and installing, refer to => [ End Cover ] End Cover
23 Gasket
• Replace
24 Centering pins
25 Seal
• Replace
26 Oil drain plug
CAUTION!
Danger to the oil pan thread.
• Lubricate the oil drain plug threads.
• Tighten the oil drain plug using a torque wrench.
• 10 Nm
27 Bolt
• 9 Nm
28 Seals
• Replace
29 Bolt
• 9 Nm
Lower Section of Oil Pan, Tightening Specifications and Sequence
- Tighten the bolts on the flange - arrow - and intake tubes - 1 - in 3 stages as follows:
- Tight bolts by hand in a diagonal sequence.
- Pre-tighten all the bolts in a diagonal sequence to 5 Nm.
- Tighten the bolts in a diagonal sequence to 9 Nm.