Passive Occupant Detection System Assembly Overview

Passive Occupant Detection System Assembly Overview

CAUTION!
• Follow the safety precautions for pyrotechnic components.

• Follow the additional safety precautions for working on the passenger airbag deactivation seat occupied recognition system => [ Passive Occupant Detection Sensor Safety Precautions ] Service Precautions.

• Follow the procedure for the passenger airbag deactivation seat occupied recognition system after an accident.

• The replacement part (service kit) for the seat occupied recognition system is already pre-calibrated and must not be separated under any circumstances.

CAUTION!
The passenger occupant detection system service kit is precalibrated and must not be disconnected. The service kit consists of:

• Seat Occupied Recognition Control Module (J706)

• Seat Occupied Recognition Pressure Sensor (G452)

• Passive Occupant Detection System Mat

• Seat cushion

• Wiring harness between the seat occupied recognition control module (J706) and the Seat Occupied Recognition Pressure Sensor (G452).





1 Seat Occupied Recognition Control Module (J706)

2 Bolt

• Quantity: 2

• 2.5 Nm

3 Electrical connection

• On the Seat Occupied Recognition Control Module (J706)

4 Seat Occupied Recognition Pressure Sensor (G452)

5 Pressure Hose

6 Connector Between Service Kit and Seat Wiring Harness

7 Electrical Connection

• On the seat occupied recognition pressure sensor (G452)

8 Guide Clip

9 Retaining Bracket