Ignition Switch

Ignition Switch

Removing





- Remove steering column trim.

- Destroy cover cap retainer - 2 - on ignition switch.

- Pry the cover cap - 1 - out of the ignition switch.

- Disconnect electrical connector - 1 -.





- Release retaining clip by inserting jeweller's screwdrivers - 2 -.

If the procedure is not possible because there is not enough space, assisting tools must be created from 2 wire hooks as follows.





- Take a dia. 1 mm welding wire and bend the end to form an eye.

- Then cut the wire.

• Dimension - a - = approximately 50 mm.

- File the end of the wire hook into a point.

• Dimension - b - = 5 mm

- Remove ignition switch - 3 - in - direction of arrow - from steering lock housing. The jeweller's screwdriver or wire hooks must remain inserted.





Installing

Install in reverse order of removal, observing the following:

- The ignition switch must slide into the steering lock housing until it engages audibly.