Battery, Disconnecting and Connecting

Battery, Disconnecting and Connecting

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Vehicle Damage Warnings.

Disconnecting





- Press the battery cover to the side - arrow A - and remove it upward - arrow B -.

- Loosen nut several turns and remove ground wire terminal clamp - arrow - from battery terminal.





Connecting

• Tightening specification, refer to => [ Battery Assembly Overview ] Battery Assembly Overview.

- To connect, connect terminal clamp of ground wire by hand to battery negative terminal - and tighten nut.

When the battery is connected, the following steps must be performed:

• Activate the one-touch up/one-touch down power window regulators. Refer to the owner's manual.

• Synchronize secondary and additional keys to ensure remote control operation. To do so, insert key into ignition lock, switch the ignition on and off again and remove key.

• Check DTC memories of all control modules and erase Undervoltage DTC if necessary.

• After connecting the power supply, the ABS warning lamp may only go out after the vehicle has been driven a few yards.