Backrest Cover and Upholstery

Backrest Cover and Upholstery





1 Backrest Cover

Removing

- Remove the seat. Refer to => [ Seat ] Seat.

- Remove the backrest. Refer to => [ Backrest ] Backrest.

- Remove both outer parts of belt guide => [ Outer part of belt guide, removing and installing ] Backrest Cover.

- Pry grip channel at edge of backrest cover - 1 - all around out of guide at backrest - 6 -. Refer to => [ Pry grip channel for backrest cover out of guide ].

- in bending sections, grip channel is also secured using clips - 3 -, carefully remove clips.

- Carefully loosen seams of backrest cover from Velcro fastener at backrest cushion - 4 -.

- Disengage lower retaining strip at pneumatic block - 5 -.

- Remove backrest cover.

Installation

To install, perform the steps used in removal in reverse order.

2 Belt Guide, Outer Part

• Removing and installing, refer to => [ Outer part of belt guide, removing and installing ] Backrest Cover

3 Clips

Quantity: 8

• For grip channel of backrest cover

• Install in bend in backrest

4 Backrest Padding

Removing

- Remove backrest cover - 1 -.

- Disengage flaps for backrest bolster inflation adjustment - 7 - at retaining bracket of backrest => [ Disengaging flap for backrest bolster inflation
adjustment ].

- Disconnect pneumatic hose to backrest bolster inflation adjustment.

- Remove backrest cushion from backrest.

Installation

To install, perform the steps used in removal in reverse order.

5 Pneumatic Block

Removing

- Remove backrest cover - 1 -.

- Remove backrest cushion - 4 -.

- Carefully loosen bonding of pneumatic block from backrest.

- Swing pneumatic block toward front at upper edge.

- Free up electrical wiring harness.

- Remove pneumatic block.

Installation

To install, perform the steps used in removal in reverse order.

- If necessary, replace double adhesive tape.

• Assignment of pneumatic block. Refer to => [ Pneumatic Block Component Assignment ] Pneumatic Block Component Assignment

6 Backrest

• Removing and installing, refer to => [ Backrest ] Backrest

7 Flap for Backrest Bolster Inflation Adjustment

• disengage => [ Disengaging flap for backrest bolster inflation
adjustment ]

Pry grip channel for backrest cover out of guide





- Starting at bottom, pry grip channel for backrest cover out of guide at backrest, using for example, an awl - arrow -; lightly press together backrest upholstery in order to release backrest cover.

Disengaging flap for backrest bolster inflation adjustment





- Swing backrest bolster inward - arrow A - and disengage flaps - 1 - for backrest bolster inflation adjustment at retaining bracket - 3 - of backrest - arrow B -.

- Disconnect pneumatic hose - 2 - to backrest bolster inflation adjustment.

- Remove backrest cushion from backrest.