Oil Pump and Lower Oil Pan Section Assembly Overview
Oil Pump and Lower Oil Pan Section Assembly Overview
1 Oil Pan Lower Section
• With oil level thermal sensor (G266)
• Lower section of oil pan, removing and installing, refer to => [ Oil Pan Lower Section ] Oil Pan Lower Section
• Oil level thermal sensor (G266), removing and installing, refer to => [ Oil Level Thermal Sensor ] Service and Repair
2 9 Nm
• Tighten diagonally in 2 stages => [ Tighten bolts for lower section of oil pan in 2 stages as follows. ] Oil Pan Lower Section
3 9 Nm
4 9 Nm
5 Oil Pipe
6 Gasket
• Replace
7 O-ring
• Replace
8 O-ring
• Replace
9 9 Nm
10 Housing
• For oil cooler by-pass valve
11 Oil Cooler By-Pass Valve
12 Gasket
• Replace
13 Oil Check Valve
14 O-ring
• Replace
15 9 Nm
16 9 Nm
17 Oil Pipe
18 O-ring
• Replace
19 Alignment Bushing
• 2 pieces
20 Driveshaft for Coolant Pump
21 Gasket
• Replace
22 Oil Pump
• Do not disassemble
• With relief valve approximately 5.5 bar
• Removing and installing, refer to => [ Oil Pump ] Oil Pump
23 Driveshaft for Oil Pump
24 Bolt
• Replace
• 8 Nm plus an additional 90° turn
25 Gasket
• Replace
26 9 Nm
27 Intake Tube
• For oil pump
28 Oil Strainer
• Clean
29 Oil Baffle
30 Bolt
• Replace
• 5 Nm plus an additional 45° turn
31 Rubber Buffer
32 9 Nm
33 Seal
• Replace
34 Oil Drain Plug
• 25 Nm