Operation CHARM: Car repair manuals for everyone.

Drive Plate






A/C Compressor



Drive Plate

- Remove drive plate with overload safeguard. Refer to => [ Drive Plate with Overload Protection ] Drive Plate With Overload Protection.

Removing

- Loosen drive plate - C - by turning using a conventional band wrench with webbed band in direction of arrow - D -, counterhold compressor shaft - A - using a retainer - B - on compressor shaft - A -.





Depending on compressor version compressor shaft varies, an open end wrench or a Socket Wrench (T10001/10) from Shock Absorber Set (T10001) or Retainer (3079) must be used to counterhold.

Installing

- When installing, coat rubber element - B - lightly using soapy water as sliding compound.





- Insert rubber element - B - in drive plate - A - according to illustration.

- Insert drive plate - A - with rubber elements - B - onto drive plate - C - according to illustration until it makes contact with compressor shaft.

This illustration shows the rubber element - B - in version "1". Rubber elements - B - of version " 2" are joined to each other at top.

- Screw drive plate - C - onto compressor shaft - A - by rotating in direction of arrow - E -.





- Tighten drive plate - C - by turning using a conventional band wrench with webbed band in direction of arrow - E - to 30 Nm, counterhold compressor shaft - A - using a retainer - B - on compressor shaft - A -.

Depending on compressor version compressor shaft varies, an open end wrench or a Socket Wrench (T10001/10) from Shock Absorber Set (T10001) or Retainer (3079) must be used to counterhold.