Turn Signal Bulb

HID Headlamps

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

• Adjust the headlamps after performing any work that could have affected their adjustment.

Turn Signal Bulb

Removing

- With ignition switched off, disconnect battery ground (ND) wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Loosen locking bolt - 1 - a few turns.





- Remove appropriate front wheel.

- Remove appropriate front wheel housing liner.

- Release retainer tabs - arrows - and detach low beam housing cover from headlamp housing.

- Remove bulbs - arrows - from housing.





- Unplug connector at bulb.

Installing

Install in reverse order of removal, observing the following:

- Push socket into reflector until it engages noticeably.

- Close housing cover and secure with screw.

- Install front wheel housing liner.

- Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal and tighten nut. ] Battery, Disconnecting and Connecting.