Battery, Disconnecting and Connecting

Battery, Disconnecting and Connecting

CAUTION!
Activate Telematics control module Service Mode before disconnecting battery. Refer to Guided Fault Finding

- Switch ignition off and remove ignition key.

- Remove right luggage compartment side trim cover - arrows -.





- Remove covers - 1 - and - 2 - over battery.





- Clamp ground wire - 2 - and positive wire - 4 - to battery.





Connect battery

- First connect positive wire pole shoe - 4 - by hand to battery positive pole "+" and tighten nut.

- Connect ground wire pole shoe - 2 - by hand to battery negative pole "-" and tighten nut.

If the battery is reconnected, the following measures must be performed:

• Deactivate Telematics control module service mode. Refer to

• Activate electric window regulator 1-touch up/down feature. Refer to Owner's Manual.

• Turn ignition key in ignition lock left as far as stop one time

If the battery was replaced, the Energy Management Control Module (J644) must be recoded. Select "Guided Fault Finding" function to do this.

• After reconnecting voltage supply, the ABS warning light may go out after driving a few meters.

Tightening Specifications