Side Rear Panel Trim Panel

Side Rear Panel Trim Panel

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)






Removing

- Move both seats forward and fold backrests forward.

• The rear bulkhead cover is only laid aside and is not removed completely.

Loosen the rear panel cover (without detaching the seat belts from the belt end fittings), refer to => [ Rear Bulkhead Cover Assembly Overview ] Rear Bulkhead Cover Assembly Overview and move it to the side.

- Remove cover - 1 - from center storage compartment - 3 -.






- Open cover - 2 - on center storage compartment - 3 -.

- Starting at the top, unclip the side rear panel trim panel - 4 - from the rear panel using the trim removal wedge (3409).

- Disconnect electrical connector on Left Rear Treble Speaker (R14) or Right Rear Treble Speaker (R16).

Installation

Install in reverse order of removal. Note the following:

• If trim clamps remain in body mounting points, remove these and insert them in trim.

• Check clamps for damage or deformation, replace if necessary.

• The carpet - 5 - and the center storage compartment - 3 - must be installed. Open center storage compartment cover - 2 - to do so.






- Attach the side rear panel trim panel - 4 - to the center storage compartment => [ (Item 12) Locking tabs ] Side Rear Panel Trim Assembly Overview with the locking tabs and then attach the trim panel to the end panel.

- Attach the side rear panel trim panel to the center storage compartment when installing the cover - 1 -.

- Fold the lip on the door seal over the side rear panel trim panel.