Selector Mechanism Assembly Overview

Selector Mechanism Assembly Overview

• Lubricate mounting points and contact surfaces with polycarbamide grease. Refer to the electronic parts catalog ETKA.





1 Mounting Bracket

• For selector lever cable

2 Bolt

• Replace

• 20 Nm plus an additional 90°

• Qty. 2

3 Lock Washer

• Replace

4 Bolt

• 13 Nm

5 Securing Plate

• Replace

6 Selector Lever Cable

• Do not bend or kink

• If selector lever cable boots are damaged, replace

• Adjusting, refer to => [ Selector Lever Cable, Adjusting ] Adjustments

• Removing and installing, refer to => [ Selector Lever Cable ] 02E Automatic Transmission

• Do not lubricate cable eye

7 Nut

• 8 Nm

• Shift mechanism to body

• Qty. 4

8 Stop Buffer for Selector Lever

• Clipped into selector mechanism

9 Selector Mechanism Function Unit

• With integrated selector mechanism circuit board (selector lever (E313))

Risk of destroying electronic selector mechanism components with static discharge.

• Do not touch circuit board with fingers.

• With integrated tiptronic switch (F189) and shift lock solenoid (N110).

• Check tiptronic switch (F189) or shift lock solenoid (N110) in guided fault finding.

• If tiptronic switch (F189) or shift lock solenoid (N110) are faulty, replace selector mechanism function unit.

• Perform selector mechanism emergency release. Refer to => [ Selector Mechanism Emergency Release, Performing ] Service and Repair

• Removing and installing. Refer to => [ Tiptronic Switch ] Service and Repair.

10 Locking Spring

11 Bolt

• 3.5 Nm

12 Pivot Pin

13 Bolt

• 3.5 Nm

• Qty. 4

14 Locking Plate

15 Selector Mechanism Shift Unit

• With bonded-on gasket

16 Nut

• Replace

• 9 Nm

• Qty. 4

• Self-locking

17 Bracket

18 Lock Washer

• Qty. 2

19 Securing Plate

• Replace