Rear Axle Toe, Adjusting

Rear Axle Toe, Adjusting

- Remove lower transverse link to subframe connection nut - A - and loosely install new nut.






- Adjust toe by turning eccentric bolt - B -.

• The maximum adjustment range is 90° to left or right of center position.

- Tighten nut - A -.

- Tightening specifications => page => [ Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview ] Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview

- After tightening nut - A -, check toe value once more => [ Vehicle Alignment Specified Values ] [1][2]Alignment.

Tightening specifications, refer to => [ Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview ] Subframe, Diagonal Brace, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview

Tightening specifications, refer to => [ Subframe, Lower Transverse Link, Upper Transverse Link, Tie Rod, Level Control System Sensor Overview ] Subframe, Lower Transverse Link, Upper Transverse Link, Tie Rod, Level Control System Sensor Overview

Tightening specifications, refer to => [ Subframe, Diagonal Braces, Crossmember, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview ] Subframe, Diagonal Braces, Crossmember, Lower Transverse Link, Upper Transverse Link, Tie Rod and Vehicle Level Sensor Overview