Rear Bulkhead Cover

Rear Bulkhead Cover

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)






Removing

- Move both seats forward and fold backrests forward.

- Remove the driver and front passenger seat belts from the outer belt end fitting. Refer to => [ Outer Belt End Fitting ] Outer Belt End Fitting.

• Both linkage removal flaps - 1 - are closed when in basic position.






- Carefully unclip the rear panel cover - 2 - around both rollover protections - 3 - using the trim removal wedge (3409).

- Then remove rear bulkhead cover - 2 - upward - direction of arrow - from body and from wind deflector or wind deflector support.

Installation

Install in reverse order of removal. Note the following:

• There are clamps - 2 - and - 3 - for the rear bulkhead cover - 1 - that must be inserted in the cover and clamps => [ (Item 6) Clips ] Rear Bulkhead Cover Assembly Overview that must be placed in the rollover protection trim (body).






• Allocate clamps according to their corresponding installation location.

• Check clamps for damage or deformation, replace if necessary.

- The tabs - 4 - must lock into the recesses in the rollover protection trim.