Seat Forward/Back Adjustment Motor V288

Seat Forward/Back Adjustment Motor V288

• If the motor is faulty, the seat pan lower frame must be replaced.

• Seat is shown without upholstery and without backrest in picture for the sake of a better illustration.

Removing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove the seat. Refer to => [ Front Seat ] Front Seat.

- Attach the front seat to the fixture for seat repair (VAS 6136). Refer to => [ Installing Front Seat On VAS 6136 ] Installing Front Seat on VAS 6136.

- Separate seat pan upper frame from lower frame. Refer to => [ Seat Pan, Disassembling and assembling ] Seat Pan, Disassembling and assembling.

• The seat angle adjustment motor and seat height adjustment motor must be installed in the new seat pan lower frame.

- Remove the seat angle adjustment motor (V243) or (V244) - 1 -. Refer to => [ Driver Seat Angle Adjustment Motor V243/V244 ] Driver Seat Angle Adjustment Motor V243/V244.






- Remove the seat height adjustment motor (V245) or (V246) - 3 -. Refer to => [ Seat Height Adjustment Motor V245 and V246 ] Seat Height Adjustment Motor V245 and V246.

2 Driver seat angle adjustment motor (V243) or front passenger seat angle adjustment motor (V244)
4 Lower seat pan frame

Installation

Install in reverse order of removal. Note the following:

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Service Precautions.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Install the seat height adjustment motor (V245) or (V246) - 3 - into the new lower frame - 4 -.






- Install the seat angle adjustment motor (V243) or (V244) - 1 - into new lower frame - 4 -.

• Make sure the connectors are installed all the way in and are secure.

- Switch on ignition.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect battery ground cable with ignition switched on.

- If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.