Telephone/Navigation System/Auxiliary Heater Antenna

Telephone/Navigation System/Auxiliary Heater Antenna

• All vehicles with a telephone and/or navigation and/or an auxiliary heater have a telephone/navigation system/auxiliary heater antenna (R66) (roof antenna).

• The antenna wires are connected to the cellular telephone amplifier (R86) and/or to the navigation system with CD drive control module (J401) at the left side of the luggage compartment.

• The antenna wire to the auxiliary heater radio receiver (R64) is routed along the right D-pillar.

• The trim must be removed from the telephone/navigation system/auxiliary heater antenna up to the control module brackets inside the luggage compartment at the rear and on the left and right side when replacing the telephone/navigation system/auxiliary heater antenna.

Removing

- Remove the trim panels on the left and right sides of the luggage compartment.

- Remove the trim on the left and right D-pillars.

- Lower the rear molded headliner.

- Remove nut - 2 - (5 Nm).





- Disconnect the antenna wire connectors from the cellular telephone amplifier/navigation system with CD drive control module/auxiliary heater radio receiver.

- Remove the telephone/navigation system/auxiliary heater antenna - 1 - from the roof.

Installing

- Mount the telephone/navigation system/auxiliary heater antenna - 1 - on the roof and align it with the drive direction.





- Install the antenna wires - 3 - into the slot on the antenna base - arrow - and install the nut - 2 - (5 Nm).

The antenna wire - 3 - must be inside the slit in the nut - 2 -.

- Align the telephone/navigation system/auxiliary heater antenna - 2 - in drive direction again before tightening nut - 3 -.

- Perform further installation in reverse order.