Instrument Cluster

Instrument Cluster

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

• Do not disassemble instrument cluster.

Removing

- If the instrument cluster was replaced with the instrument cluster control module (J285) , select the Replace function for the corresponding control module in the Guided Fault Finding or Guided Functions operating mode.

- Select the function or path






- Follow the instructions on the Vehicle Diagnosis Tester display.

- Switch off ignition and remove ignition key.

• It is not necessary to remove the steering wheel in order to remove the instrument cluster.

- Remove the steering wheel and adjustment mechanism completely and lay it down.

- Remove gap cover - 1 - in - direction of arrow -.






- Place gap cover on upper steering column trim.

- Remove screws - arrows -.






- Pull instrument cluster out until it lies on steering wheel.

- Release catches of connectors - 1 -, turn retainer in - direction of arrow - and disconnect the connector.






- Remove instrument cluster to driver's side between steering wheel and instrument cluster.

Installing

Install in reverse order of removal, observing the following:

- Follow the instructions on the Vehicle Diagnosis Tester display with a new instrument cluster.

Tightening Specifications