Brake Hose/Line

Brake Lines and Brake Hoses

The following will show the various installed locations and tightening specifications of the brake lines and brake hoses.

Brake Lines in Area of Brake Master Cylinder/Hydraulic Unit ITT Mark 60/ ITT Mark 70





1 Brake line to brake master cylinder: 14 Nm

Brake Lines in Area of Brake Master Cylinder/Hydraulic Unit ITT Mark 60/ ITT Mark 70





1 Brake line to hydraulic unit: 14 Nm

Brake Lines/Brake Hoses in area of Front Wheel - Vehicles with Front Wheel Drive





1 Hex bolt: 8 Nm
2 Brake line: 14 Nm
3 Securing clip

Brake Hose Connection with Anti-Rotation Device

- Make sure that the groove in the banjo fitting of the brake hose is inserted onto the locating tab - arrow -.





Brake Line Connection to Brake Caliper





1 Brake line - 14 Nm
3 Hex bolt 15 Nm

Brake Line Connection at Underbody





1 Brake line - 14 Nm

Brake Line/Brake Hoses in Area of Rear Axle - Vehicles with Front Wheel Drive





1 Brake line: 14 Nm
2 Securing clip
3 Install clearance retainer - 3 - on brake caliper side.

Brake Line/Brake Hoses in Area of Rear Axle - Vehicles with All Wheel Drive





1 Brake line: 14 Nm
2 Securing clip
4 Install clearance retainer - 4 - on brake caliper side.

Line Connection of Brake Line

- When fastening union bolt - 2 -, counter-hold union nut - 1 -.





• Tightening specification: 14 Nm