Center Speaker Trim

Center Speaker Trim

Removing

• Be extremely careful when removing and installing because it is easy to damage the speaker trim.

- Using a small screwdriver, carefully release the speaker trim - 1 - at the rear retaining pins - arrow - but only lift it up approximately 10 mm (0.39 in).






Do not lift the speaker trim any higher or the front retaining pins will break off.

- Insert a long screwdriver under the speaker trim at the very front - arrow A - until it comes into contact directly on the right front retaining pins.






- Carefully rotate the screwdriver in the direction of - arrow B - until the retaining pin - 1 - disengages from the guide - 2 -.

- Repeat the procedure on the remaining retaining pins - 3 -.

Installing

Install in reverse order of removal. Note the following:

- First insert the speaker trim in the instrument panel and then press it on until it engages audibly.