Rear Bumper Cover Assembly Overview, Allroad

Rear Bumper Cover Assembly Overview, Allroad

• Only the differences from the standard bumper are described

• The removal and installation of the bumper cover is performed like that of the standard bumper.






1 Spoiler

• Unlike for standard bumpers, the two left and right expanding clips must be removed first.

• Bumper cover removed.

- Release the cover hooks all around and in stages and remove from the cover toward the rear.

- When installing, the hooks must lock completely in the cover.

2 Bumper cover

When re-installing the old bumper cover, the old support piece - 7 - remains installed.

- When installing and removing bumper cover, a new support must be installed, refer to => [ Disengaging support piece ]

• Perform removal as for the spoiler.

3 Clip

4 Securing strip

5 Bolt

• 2.5 Nm

6 Bolt

• 1.5 Nm

7 Support piece

• Support piece must be installed only with a new bumper cover.

• Release => [ Disengaging support piece ]

8 Underbody Impact Guard

• Bumper cover removed.

• Remove bolts - 6 - and - 9 - and remove impact guard toward the rear.

9 Bolt

• 1.5 Nm

Loosen the expanding clip

- Push the clamping pin - 3 - up through the left and right expanding clip on the spoiler - 2 - to release.






- Remove the expanding clip from the spoiler - 2 - and the bumper cover - 1 -.

- When installing, lock the clip with the clamping pin.

Loosen the hook

- When removing the cover - 1 - or the spoiler - 5 -, release the hooks, and the hooks under the end plate- 2 -, and remove them opposite one another.






- When removing the impact guard - 2 -, remove the bolts - 3 -, release the hooks- arrows - and remove them from the spoiler toward the rear.

Installing support piece





• Support piece must be installed only with a new bumper cover.

- To remove, press catch - arrow - to the side and pull support piece downward out of cover - 1 -.

- Insert support piece - 2 - into cover as shown and let engage inside.

- Disengaging cord must be removed only when the cover is installed completely.

Disengaging support piece





Never unlock the support when it is removed. This can cause personal injury.

When re-installing the old bumper cover, the old support piece remains installed.

- When replacing the bumper cover, a new support piece must be clipped into the bumper cover from below.

- After completely installing bumper cover, disengage support piece by pulling on disengaging cord - arrow -.

• By pulling disengaging cord, tension is released from support piece and reinforces the bumper cover against the crossmember.