Outer Sill Panel Strip

Outer Sill Panel Strip

• The sill panel strip is secured to the side member using adhesive strips.

• It is not possible to remove without destroying.






1 Inner Door Seal

2 Rear sill panel trim

• Removing

- Heat the sill panel strip using a hot air gun and pull the molding upward and off.

• Installing:

- The side member must be free of dirt and grease in the adhesive area.

- Warm the adhesive areas to approximately 40 °C using a hot air gun.

- Remove protective film from adhesive tape.

- Insert the sill panel strip with the centering pins in the side member and press it on firmly in stages from front to back.

3 Front sill panel trim

• Removal and installation same as with rear sill panel strip.

4 Adhesive tape

• Pull off protective foil before installing.