Lock Cylinder Overview

Lock Cylinder Overview

• The assembly overview is based on the latching for the left 1/3 backrest. The latching of the right 2/3 backrest is similar.






1 Backrest Shell

2 Key

3 Lock Cylinder

• Removing and installing, refer to => [ Lock Cylinder ] Lock Cylinder

• Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.

• Check the installation position when installing the lock cylinder. It is not possible to lock the backrest correctly if the installation position is not correct.

4 Protective Cap

• For lock cylinder

• Remove before installing the lock cylinder

The key must be inserted in the lock cylinder correctly before the protective cap is removed. If that is not done, the tumblers and compression springs can fall out and the lock will be ruined.

5 Trim

• For locking and lock cylinder

• Removing and installing, refer to => [ Lock Trim, with Lock Cylinder ] Lock Trim, With Lock Cylinder

6 Locking Tab

• For backrest

• Removing and installing, refer to => [ Backrest Lock ] Backrest Lock

7 Bolt

• 2 per retainer

• 25 Nm