Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2011 >> A4 Sedan (8K2) L4-2.0L Turbo (CAEB) >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Removal and Replacement >> Power Standard Front Seats With or Without Memory Function >> Power Standard Front Seat

Power Standard Front Seat







Power Standard Front Seat

• Removal and installation is described for the driver seat. The passenger seat is similar.

Removing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Remove the front belt anchor. Refer to => [ Front Belt End Fitting ] Front Belt End Fitting.

- Move the seat into its service position. Refer to => [ Front Seats, Bringing Into The Service Position ] Front Seats, Bringing Into the Service Position.

- Remove the front bolts - 1 - (quantity 2) to the console - 4 -.






- Operate seat forward/back adjuster and move the seat - 2 - as far forward as possible.

- Remove the rear bolts - 1 - (quantity 2) to the console - 3 -.

- Turn on the ignition.

- Disconnect the battery ground cable from the battery with the ignition on.

Before handling airbag components (for example, disconnecting the electrical connector), the relevant person must discharge static electricity. This can be done by touching the door striker, for example.

- Disconnect the connectors at the connector station in the floor panel. Refer to => [ Disconnecting and Connecting the Harness Connectors ] Disconnecting and Connecting the Harness Connectors.

- Connect (VAS 6281). Refer to => [ Connecting ] Airbag Adapter (VAS 6281) Connecting.

- Raise the front seat with a 2nd technician and remove it from the vehicle.

Installing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

Install in reverse order of removal. Note the following:

- Remove the (VAS 6281) only after installing the front seat. Refer to => [ Connecting ] Airbag Adapter (VAS 6281) Connecting.

• Make sure the connectors are installed all the way in and are secure.

- Connect the connectors to the connectors of the connector station in the floor. Refer to => [ Disconnecting and Connecting the Harness Connectors ] Disconnecting and Connecting the Harness Connectors.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.

Tightening specifications, refer to => [ Power Standard Front Seat Overview ] Power Standard Front Seat Overview.

pro multis · About Operation CHARM