Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2011 >> A4 Sedan (8K2) L4-2.0L Turbo (CAEB) >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Removal and Replacement >> Power Standard Front Seats With or Without Memory Function >> Storage Compartment

Storage Compartment







Storage Compartment

Removing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Remove the front seat:

• Standard seat and sport seat (manual). Refer to => [ Manual Standard Front Seat ] Manual Standard Front Seat.

• Standard and sport power seat, comfort seat and super sport seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

- Attach the front seat to the (VAS 6136) => [ Front Seats, Installing on the ] Front Seats, Installing on the Fixture For Seat Repair (VAS 6136).

- Open the storage compartment - 1 - and remove the bolts - 2 -.






- Release the tab - arrow - on the storage compartment - 2 - and remove the storage compartment downward from the sill-side trim - 1 -.






- Push the storage compartment - 1 - in the direction of the - arrow - and disengage the retainer - lower arrow - from the upper seat frame - 2 -.






- Remove the storage compartment from the seat pan upper frame.

Installing

• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

Installation is in reverse order of removal. Be sure to note the following:

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle Diagnostic Tester.

Tightening specifications, refer to => [ Storage Compartment Overview ] Storage Compartment Overview.

pro multis · About Operation CHARM