Body, Front (Plenum Chamber Cover)

Body, Front

=> [ Plenum Chamber Cover ]

Plenum Chamber Cover

• Note different versions.

• Additional covers may also have to be removed first depending on vehicle equipment.





1 Right Auxiliary Cover

• Remove the front clip first when removing.

• The cover and the plenum chamber cover may be one piece depending on vehicle equipment.

• Lift the front cover and remove it from the plenum chamber cover.

2 Plenum Chamber Cover

• Windshield wiper arms removed.

• The left, center and right auxiliary covers are removed.

• Remove the clamps - 3 -.

• For easier removal/installation, spray windshield edge strip with soapy solution.

• Remove trim panel upward diagonally from edge frame beginning at window edge.

CAUTION!
Risk of window breaking during installation

Do not hit the trim when installing it.

Carefully press in trim sideways, beginning in the edge frame.

3 Clips

• Slide the clamps to the places shown after removing the plenum chamber cover.

4 Windshield

Auxiliary Covers, Removing





1 Center Auxiliary Cover

• First unclip the bottom front, then loosen the rear retainers - 2 - (press together lightly from below) and remove it upward from the plenum chamber cover.

2 Catch

• While removing, lightly compress it at the bottom and slide it out.

3 Left Auxiliary Cover

• First unclip the bottom front, then loosen the rear retainers and remove it upward out of the plenum chamber cover.

4 Plenum Chamber Cover

5 Plenum Chamber Cover Retainers