Front Bumper Cover

Front Bumper Cover

Removing






- Remove the bumper cover. Refer to => [ Lock Carrier Cover ] Lock Carrier Cover.

- Disconnect the electrical connector - 2 - for the outside air temperature sensor (G17) and the electrical connector - 1 - for the front parking aid sensor.

- Remove the bolt - 3 -.






- Remove the bolt - 2 - and the quick-release coupling - 1 - on the front bumper noise insulation.

- Remove wheel housing liner. Refer to => [ Front Wheel Housing Liner ] Front Wheel Housing Liner.






- Disconnect the electrical connector - 1 - on the fog lamp.

- Remove the bolts - arrows -.

- Disengage the side walls on the front side panel and remove the bumper cover forward.

Installation

• Gap dimensions, refer to => [ Front Bumper Cover Gap Dimensions ] .

• Tightening specifications, refer to => [ Bumper Cover Overview ] Bumper Cover Overview.

Installation is reverse of removal, but note the following:

- Install wheel housing liner. Refer to => [ Front Wheel Housing Liner ] Front Wheel Housing Liner.

- Install the lock carrier cover. Refer to => [ Lock Carrier Cover ] Lock Carrier Cover.