Impact Member

Impact Member

Removing






• When installing, position cable ties in same place.

- Remove front bumper cover. Refer to => [ Front Bumper Cover ] Front Bumper Cover.

- Disconnect the electrical connector - 4 - on the horns and free up the electrical wiring harness - 3 - on the horn bracket.

- Free up the washer nozzle water drain hose by disconnecting the cable tie - 1 -.

- Remove the bolts - arrows - and the bumper cover spacer - 2 -.

- Remove the impact bar - 5 - from the mounts.

• Pry the impact bar out of the mounts if it is not easy to remove.

Installation

• Tightening specifications. Refer to => [ Impact Member Overview ] Impact Member Overview.

Installation is reverse of removal, but note the following:

- Install the front bumper cover. Refer to => [ Front Bumper Cover ] Front Bumper Cover.