Right Impact Member Mount

Right Impact Member Mount

Removing

- Remove front bumper cover. Refer to => [ Front Bumper Cover ] Front Bumper Cover.

- Remove the side impact bar. Refer to => [ Impact Member ] Impact Member.

- Mark the installation position of the mount to the lock carrier for installation later.

- Remove the bolts - arrows -.






- Remove the locating bolt - 1 -.

- Remove the impact member mount - 2 - on the lock carrier.

Installation

• Tightening specifications, refer to => [ Impact Member Overview ] Impact Member Overview.

Installation is reverse of removal, but note the following:

- Tighten the impact member mount according to the marking made during removal.

- Install the impact member. Refer to => [ Impact Member ] Impact Member.

- Install the front bumper cover. Refer to => [ Front Bumper Cover ] Front Bumper Cover.