Hood Seal

Hood Seal






1 Gasket for Plenum Chamber

• To remove, pull back from the body flange at the sides.

• When installing, slide it into the sealing profile with pre-tension beginning at the sides.

• Press seal onto opposite side in stages.

• Slide seal into sealing profile on opposite side.

• Compress the excess length along the plenum chamber bulkhead.

2 Right Sealing Profile

• To remove, unclip from the body and remove it sideways under the fender flange.

• When installing, the clips on the foam piece must engage in the body.

3 Plenum Chamber Front Panel

• Slide the plenum chamber seal on at the sides.

4 Left Sealing Profile

• To remove, unclip from the body and remove it sideways under the fender flange.

• When installing, the clips on the foam piece must engage in the body.