Memory Seat/Steering Column Adjustment Control Module

Memory Seat/Steering Column Adjustment Control Module

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

Removing


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

- Remove front seat:

• Standard and Sport Power Seat, Comfort Seat and Super Sport Seat. Refer to => [ Power Standard Front Seats ] Power Standard Front Seats.

- Attach front seat to Fixture For Seat Repair (VAS 6136) => [ Front Seat, Installing on Fixture for Seat Repair VAS 6136 ] Front Seat, Installing on Fixture for Seat Repair VAS 6136.

- Disconnect the connectors - 2 through 5 - on the control module - 1 -.





• The number of connectors may vary depending on the equipment. The description shows the version with the most equipment.

- Unclip the tabs - arrows - using the trim removal wedge (3409).

- Carefully tilt the control module - 1 - in the - direction of arrow A - out of the retainers - 2 -.





- Slide the control module in the - direction of arrow B -.

- Disengage the control module hooks - arrow - from the bracket.

- Remove the control module from the bracket.

Installation


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Make sure the memory seat adjustment control module engages audibly in the retainer.

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.