Hydraulic Cylinder Bracket

Hydraulic Cylinder Bracket

Special tools, testers and auxiliary items required

• Pop Rivet Pliers (VAS 5072)

• Drill

• Pop Rivets Refer to Electronic Parts Catalog (ETKA)

Injury risk.

• There must be no pressure inside the hydraulic system when performing the following work.

Removing






- Open the convertible top half way.

- Turn off the ignition and press the convertible top operation switch (E137) - 1 - for approximately 5 seconds.

• The pressure in the hydraulic system will come down.

- Remove the convertible top headliner - 3 - upward near the cover - 4 - and move it to the side with the help of a 2nd technician.






- Version 1: Remove the blind rivet - 1 - and strike the rivet shaft.

- Remove the bolt - 2 -.

- Pull off the cover.

- Version 2: Remove the bolts - arrows -.






- Pull off cover - 1 -.

- Remove the clips - 3 - and then remove the bolts - 4 -.






- Remove the washers - 5 - while removing the bolts.

- Remove the bolts - 1 - from out of the mount on the hydraulic cylinder - 2 - - arrow -.

- Remove the hydraulic cylinder.

- If the hydraulic cylinder is being replaced:

• Removing the hydraulic line, refer to => [ Hydraulic Line On Cylinder ] Hydraulic Line On Cylinder.

- If one hydraulic line is being replaced:

• Remove the hydraulic line from the hydraulic cylinder. Refer to => [ Hydraulic Line On Cylinder ] Hydraulic Line On Cylinder.

• Remove the hydraulic line from the valve block. Refer to => [ Hydraulic Line On Valve Block ] Hydraulic Line On Valve Block.

Installation

Install in reverse order of removal. Note the following:

- Install the hydraulic line. Refer to => [ Hydraulic Line On Cylinder ] Hydraulic Line On Cylinder and => [ Hydraulic Line On Valve Block ] Hydraulic Line On Valve Block.

- Hydraulic system, filling and bleeding, refer to => [ Hydraulic System, Filling and Bleeding ] Hydraulic System, Filling and Bleeding.