Entry Assistance Cover

Entry Assistance Cover

Special tools, testers and auxiliary items required

• Pry lever (80 - 200)

Removing





- Remove the entry assistance trim. Refer to => [ Entry Assistance Trim ] Entry Assistance Trim.

- Remove the backrest cover and cushion. Refer to => [ Backrest Cover and Cushion ] Backrest Cover and Cushion.

- Remove the clips - 1 and 3 - on the backrest frame using the pry lever (80 - 200).

- Remove the cover - 2 - from the bracket - arrows -.

Installation


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.