Adhesive Tape Surfaces

Adhesive Tape Surfaces

• The vehicle must be at room temperature before the installation of self-adhesive cover, door seal molding, etc. when using adhesive tape.

• The adhesive surfaces on the body must be free of dirt and grease.

• Clean the adhesive surfaces using cleaning solution (D 009 401 04).

• Apply some adhesive (D 355 205 A2) on the adhesive surface on the body side using using applicator (D 009 500 25) and let it dry.

• Warm the adhesive areas to approximately 40 °C (104 °F) using a hot air gun.

• After installing the covers with adhesive tape, use a roller and press the adhesive tape one more time to make sure it is on securely.

• After that, pull on the adhesive tape by hand just to make sure it is on.