Front Side Marker Lamp Bulb Control Module (M33)/(M34)

Front Side Marker Lamp Bulb Control Module (M33)/(M34)

Removing






- Right side: remove the air filter housing.

- Turn the housing cover - 1 - counter-clockwise - arrow - and remove it from the headlamp housing.

- Turn the height adjustment bolt all the way with the hex socket wrench - 5 - - arrow A -






- Open the tabs - 1, 6 - and remove the control module - 2 - in the direction of travel forward from out of the guide rails - arrow B -.

- Remove the control module toward the rear out from the headlamp housing - 3 - - arrow C -, as shown on the illustration.

- Disconnect the electrical connector - 4 -.

Installing

Install in reverse order of removal. Note the following:

- Close the housing cover clockwise.

- Right side: install the air filter housing.

- Adjust the headlamp. Refer to => [ Halogen Headlamp, Adjusting ] Halogen Headlamp, Adjusting.