Continuously Variable Transmission/Transaxle: Locations
Electrical and Electronic Components and Component Locations
Data Link Connector (DLC)
• Installed location: The DLC for the vehicle diagnosis tester is inside the footwell on the driver side.
• Determine the cause of the malfunction as accurately as possible using Guided Fault Finding, OBD and Test Instruments before starting any repairs on the transmission vehicle diagnosis tester.
Transmission Control Module (TCM) (J217)
• Installed location: The TCM is at the back of the transmission, secured directly to hydraulic control module.
The following components are integrated in the TCM:
1. Connector to the hydraulic control unit, on solenoid valve 1 (N88)
2. Connector to the hydraulic control module, on the automatic transmission pressure regulating valve 2 (N216)
3. Connector to the hydraulic control module, on the automatic transmission pressure regulating valve 1 (N215)
4. Transmission input speed sensor (G182) and transmission input speed sensor 2 (G612)
5. Automatic transmission hydraulic pressure sensor 1 (G193)
6. Multifunction transmission range switch (F125)
7. Automatic transmission hydraulic pressure sensor 2 (G194)
8. Transmission output speed sensor (G195)
• On Board Diagnostic (OBD) monitors the TCM.
Hydraulic Control Module
• Installed location: The hydraulic control module is attached to the back of the transmission. The TCM is attached directly to the hydraulic control module.
A Solenoid valve 1 electrical connector
B Automatic transmission pressure regulating valve 2 electrical connector
C Automatic transmission pressure regulating valve 1 electrical connector
• The OBD monitors the valves.
Selector Lever Sensor System Control Module (J587) and Tiptronic Switch (F189)
• Installed location: The selector lever sensor system control module and the tiptronic switch are a single unit - 2 -, which is clipped to the selector mechanism function unit - arrows -.
=> [ Selector Lever Sensor System Control Module (J587) and Tiptronic Switch (F189) ] Service and Repair.
Shift Lock Solenoid (N110)
• Installed location: The shift lock solenoid - 1 - is clipped to the selector mechanism.
=> [ Shift Lock Solenoid (N110) ] Service and Repair.
Transmission Park Selector Switch (F305)
• Installed location: The transmission park selector switch, which consists of two reed contacts - 1 and 2 -, is installed on the circuit board - B - on the shift lock solenoid - A -.
• The transmission park selector switch can only be replaced together with the shift lock solenoid.
Kick Down Switch (F8)
• A specific value from the accelerator pedal position sensor (G79) and the accelerator pedal position sensor (G185) is stored in the Engine Control Module (ECM).
• Installed location: The accelerator pedal position sensors are integrated inside the accelerator pedal module - arrow -.
• If the accelerator pedal sensor is faulty, then replace the accelerator pedal module.
Transmission Range Display (Y6)
• Installed location: The transmission range display is integrated in the instrument cluster.
• The transmission range display can only be replaced with the instrument cluster.
Selector Lever Transmission Range Position Display Unit (Y26)
• Installed location: The selector lever transmission range position display unit - 1 - is installed in the center console.
Removing and installing, refer to => [ Selector Lever Transmission Range Position Display Unit (Y26) ] Selector Lever Transmission Range Position Display Unit (Y26).