Entry Assistance Handle with Bracket

Entry Assistance Handle with Bracket

Removing





- Remove the entry assistance trim. Refer to => [ Entry Assistance Trim ] Entry Assistance Trim.

- Remove the backrest cover and cushion. Refer to => [ Backrest Cover and Cushion ] Backrest Cover and Cushion.

- Disengage the connecting cable. Refer to => [ Connecting Cable ] Connecting Cable.

- Press the handle - arrow - forward as far as the stop and hold it in that position.

- Remove the bolts - 1 -.

- Remove the handle with bracket - 2 - from the backrest frame entry assistance support plate.

- Disengage the straps - arrows A - on the backrest frame.

Installation


• Follow the safety precautions for pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Ensure that electrical connections are pushed in as far as stop and engage with a click.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Disconnect the battery ground wire with the ignition switched on.

• If Airbag Malfunction Indicator Lamp (MIL) (K75) indicates a fault after installation, DTC memory must be checked, deleted and checked again.

Tightening specifications, refer to => [ Entry Assist Backrest Release Assembly Overview ] Entry Assist Backrest Release Assembly Overview.