Fuel Rail

Fuel Rail

If the fuel rail is removed or replaced, the intake manifold runner position sensor (G336) must be adapted to the Engine Control Module (ECM) (J623). Refer to "Guided Functions".

• Intake manifold must be removed, removing, refer to => [ Intake Manifold ] Intake Manifold.

- Open the hose clamp - 1 -.

- Remove hoses from the Evaporative Emission (EVAP) canister.

- Open the fuel line on the fuel rail.

- Loosen both bolts - arrows - from the fuel rail.






- Remove the fuel rail from the intake manifold.

Installing

- Always replace both fuel supply line connections.

- Tighten the fuel line.

- Connect the electrical connector.

- Install intake manifold. Refer to => [ Intake Manifold ] Intake Manifold.

• Tightening specifications: Intake manifold assembly overview, refer to => [ Intake Manifold Overview ] Intake Manifold Overview

• Tightening specifications: Fuel rail assembly overview, refer to => [ Fuel Rail Overview ] Fuel Rail Overview

- Install in reverse order of removal.