Windshield Assembly Overview

Windshield Assembly Overview






1 Windshield

• Removal and installation, refer to => [ Windshield ]

• Align the window glass on the left and right sides dimension b when installing

• Height adjustment, refer to

2 Drip Rail

• Press into clamping strip only after window adhesive curing time has elapsed.

3 Window Adhesive

• Note varying spacing dimensions to window edge.

• Dimension - A - = 7 mm

• Dimension - C - = 7 mm

• Dimension - D - = 23 mm

• Observe curing times, refer to => [ Minimum Curing Times ] Minimum Curing Times.

4 Spacer

5 Retaining Strip

6 Retaining Strip for Plenum Chamber Cover

• No replacement part

• Install the plenum chamber cover into the retaining strip only after the window adhesive curing time is complete.

• Remove the protective piping before installing the plenum chamber cover on a new window glass. Refer to => [ Removing protective piping ].

Windshield height adjustment





- Align the window glass - 1 - from side to side and adjust it to dimension - a - = 43.5 mm to the hole in the roof frame - 2 -.

- Secure the window glass from sliding out using an adjusting wedge on the bottom edge of the glass.

- Install the rail for the seal and secure the window glass with adhesive tape.

Removing protective piping





- For a new window, protective piping - 2 - must be pull out of retaining strip - 3 - of windshield - 1 - before assembling plenum chamber cover - 4 -.