Operation CHARM: Car repair manuals for everyone.

Door Window







Door Window

Removing






- Remove the door trim panel..

- Remove the sealing plugs - 2 - and - 4 -.

- Run the door window down until the bolts in the opening are visible.

- Remove the screws - 1 - and loosen the screw - 5 - a few turns.

Remove the rear bolt - 1 - completely. Otherwise, the door window cannot be removed.

- Tilt the rear door window - 3 - toward the outside out of the mount in the clamping brackets.

- Remove the door window upward out of the clamping bracket and remove it from the door - arrow -.

Installation

Gap dimensions, refer to => [ Door Window Adjustment Dimensions ] Door Window Adjustment Dimensions.

Tightening specifications, refer to => [ Door Window Overview ] Door Window Overview.

Install in reverse order of removal. Note the following:

- Insert the door window forward into the door window guide diagonally and then rotate it back into the door shaft.

- Carefully side the door window parallel down into the clamping brackets. Make sure the door window in the front window guide does not slip out.

- Press the door window down into the clamping brackets.

Before installing the rear bolt, make sure the door window is seated in the clamping bracket mount.

- Tighten the bolts.

- Adjust the door window. Refer to => [ Door Window, Adjusting ] Door Window, Adjusting.