Wiper Arm, Adjusting

Wiper Arm, Adjusting

Procedure

- Position wiper arm with wiper blade installed at wiper axle and align wiper blade at rear window as follows:





• Dimension - a - = 27 mm

• Dimension is the gap between tip of wiper blade and lower edge of window.

- Tighten the wiper arm nut.

• Tightening specification, refer to => [ Rear Window Wiper Assembly Overview ] Rear Window Wiper Assembly Overview.

- Switch on ignition.

- Activate rear wipe and let wiper arm run to end position.

- Check adjustment of wiper arm again, correct if necessary.